⇧⇧Troubleshooting Wasco-mat and Electrolux Error. Troubleshooting Gen 6 Dryers.
Error Description & code
E 01 Inlet air - input temperature is too high The temperature of the air entering the drum is too high.
E 02 Outlet air - Output temperature is too high The temperature of the air leaving the drum is too high.
E 03 Inlet air - Sensor has short-circuited The thermistor element measuring the air inlet temperature to the drum, or the wiring to the sensor has shorted.
E 04 Outlet air - Sensor has short-circuited The thermistor element measuring the air outlet temperature from the drum, or the wiring to the sensor has shorted.
E 05 Blower motor Motor 1: The thermal protection switch in the motor, or its harness, is open.
E 06 Drum motor – Motor 2: The thermal protection switch in the motor, or its harness, is open.
E 07 Option Not in use.
E 08 Inlet and Outlet air protection - thermostats One of the proctection thermostats has opened due to overheating.
E 09 Lint drawer - Lint drawer must be emptied (close) before start.
E 10 Setting Programming - error / incorrect or missing parameter(s).
E 11 Drying error - Maximum allowable RMC time exceeded (non-coin operated models only).
E 12 Drying error - Maximum allowable Autostop time exceeded (non-coin operated models only).
E 13 Drying error - Requested drying time is longer than maximum allowed.(dryer connected to a payment system).
E 14 Gas error - A flame was not detected on gas heated dryers.
E 15 Vacuum switch - The vacuum switch does not shut within 5 seconds after the dryer is started.
E 16 Vacuum switch - The vacuum switch was already closed when an attempt to start the dryer was made.
E 17 Input sensor disconnected - The inlet thermistor or wiring to the thermistor is open.
E 18 Output sensor disconnected - The outlet thermistor or wiring to the thermistor is open.
E 19 Option Not in use.
Gen 6 washer
No comments:
Post a Comment