Emerald and Selecta Control.

W620 - W675

Emerald and Selecta Control.

Error and Text.

01E Water level ACK not received within the prescribed time.

02E No signal from the ”Door closed” switch during programmer operation.

03E No signal from the ”Door locked” switch at programmer start or during programmer operation.

04E The temperature sensor indicates a temperature below -5°C or interruption in sensor.

05E The temperature sensor indicates a temperature above 98°C or short-circuit in sensor.

06E The water level is too high at programmer start (above the safety level).

07E The water level is too high during programme operation (above the measurable level).

08E The water level rises too slowly.

10E The water level is above the safety level after the drain sequence.

11E Mechanical unbalance always activated.

12E The programme unit cannot read the programme memory (EPROM).

13E The programme unit cannot communicate with the motor controller.

14E The water level system has not been calibrated (hardware calibration).

17E The signal from the ”Door locked” switch is present although there is no signal from the ”Door closed” switch.

18E CALCAD 4400 doesn´t allow start of selected program.

19E Communication between CALCAD 4400 and the programme unit card has been interrupted.

21E Microprocessor error (Configuration register).

22E The level system indicates such a wrong value at program start that the automatic level calibration cannot correct the fault.

31E The motor controller indicates the temperature is too high on the motor controller heat dissipater.

32E The motor controller indicates the thermal protector of the motor has triggered.

33E The motor controller receives a start command from the programmer unit without receiving an interlock ACK (”Door locked” signal).

35E The motor controller indicates a short-circuit in the motor windings, cabling or internally in the motor controller.

36E The motor controller indicates an error in the interlock receiving circuit.

37E The motor controller indicates the DC voltage

38E The motor controller indicates the DC voltage level is too high.

41E The motor controller indicates an error in the thermal protection circuits of the motor.

45E The RDC card indicates tacho pulses missing at requested revolution